Inside Rearview Mirror Replacement Except DD8

1. Disconnect the inside rearview mirror electrical connector.
2. Loosen the mirror mount tension screw.
3. Slide the mirror up off the mirror bracket.

1. Slide the rearview mirror down onto the bracket.
2. Connect the electrical connector.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Tighten the mirror tension screw.

Tighten
Tighten the rearview mirror mount tension screw to 1.5 N·m (13 lb in).

Inside Rearview Mirror Replacement DD8

1. Remove the electrical connector (1) from the back of the inside rearview mirror.




Notice: Do NOT pull rearward on the rearview mirror while installing or removing the mirror. Damage to the support or to the windshield may occur.

2. Rotate the mirror COUNTERCLOCKWISE until an audible click is heard.
3. Remove the inside rearview mirror.

1. Install the electrical connector (1) to the back of the inside rearview mirror.



2. Center the bottom of the inside rearview mirror on the support.

Notice: Do NOT pull rearward on the rearview mirror while installing or removing the mirror. Damage to the support or to the windshield may occur.

3. Rotate the mirror COUNTERCLOCKWISE until an audible click is heard. An audible click is heard when the inside rearview mirror is fully seated.