Tools Required

Notice: Do not turn the crankshaft assembly after the timing chain has been removed in order to prevent damage to the piston assemblies or the valves.

1. Remove the oil pump. Refer to Oil Pump, Screen, and Crankshaft Oil Deflector Replacement .
2. Remove the camshaft sprocket bolts (206).
3. Remove the camshaft sprocket (205) and timing chain (208).



4. Remove the bolts (231) and timing chain dampener (232).



5. Use the J 8433 , J 41816-2 and J 41558 in order to remove the crankshaft sprocket.



6. Remove the crankshaft sprocket.



7. Remove the crankshaft sprocket key (if required).
8. Clean and inspect the timing chain and sprockets. Refer to Camshaft Timing Chain and Sprocket Cleaning and Inspection .

1. Install the key into the crankshaft keyway, if previously removed.



2. Tap the key (122) into the keyway until both ends of the key bottom onto the crankshaft.



3. Install the crankshaft sprocket onto the front of the crankshaft. Align the crankshaft key with the crankshaft sprocket keyway.



4. Use the J 41478 (1) and the J 41665 (2) in order to install the crankshaft sprocket.

Install the sprocket onto the crankshaft until fully seated against the crankshaft flange.

5. Rotate the crankshaft sprocket until the alignment mark is in the 12 o'clock position.

Notice: Refer to Fastener Notice in the Preface section.




6. Install the timing chain dampener (232) and bolts (231).

Tighten
Tighten the timing chain dampener bolts to 25 N·m (18 lb ft).




7. With the timing chain dampener properly installed, the heads of the bolts (231) should install to flush or below the face of the guide (232).




Important: 

•	Properly locate the camshaft sprocket onto the locating pin of the camshaft.

•	The sprocket teeth and timing chain must mesh.

•	The camshaft and the crankshaft sprocket alignment marks MUST be aligned properly.

Position the camshaft sprocket alignment mark in the 6 o'clock position.

8. Install the camshaft sprocket (205) and timing chain (208). If necessary, rotate the camshaft or crankshaft sprockets in order to align the timing marks.
9. Install the camshaft sprocket bolts (206).

Tighten
Tighten the camshaft sprocket bolts to 25 N·m (18 lb ft).




10. Inspect for proper alignment of the camshaft and crankshaft sprocket timing marks (1, 2).
11. Install the oil pump. Refer to Oil Pump, Screen, and Crankshaft Oil Deflector Replacement .