GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Corvette 🢒 Body and Accessories 🢒 Doors 🢒 Door Control Module Replacement

Removal Procedure

    Object Number: 63818 Size: SH
  1. Remove the door trim panel. Refer to Door Trim Panel Replacement .

    2. Object Number: 63840 Size: SH
  2. Remove the screws attaching the door control module.
  3. Disconnect the electrical connectors.

Installation Procedure

    Object Number: 63840 Size: SH
  1. Position the door control module to the door.
  2. Connect the electrical connectors.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the screws attaching the module.

    4. Tighten
    Tighten the door control module attaching screws to 3 N·m (27 lb in).


    Object Number: 63818 Size: SH
  4. Install the door trim panel. Refer to Door Trim Panel Replacement .