GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Corvette 🢒 Restraints 🢒 SIR 🢒 Enabling the SIR System

    Object Number: 68617 Size: SH
  1. Remove the key from the ignition switch.
  2. Connect the passenger yellow 2-way connector (C213) located near the base of the steering column.

    3. Object Number: 68616 Size: SH
  3. Install the connector position assurance (CPA) to the passenger yellow 2-way connector located near the base of the steering column.

    4. Object Number: 68614 Size: SH
  4. Connect the driver yellow 2-way connector (C211) located at the base of the steering column.

    5. Object Number: 68613 Size: SH
  5. Install the connector position assurance (CPA) to the driver yellow 2-way connector located at the base of the steering column.

    6. Object Number: 68610 Size: SH
  6. Install the sound insulator-LH. Refer to Instrument Panel Insulator Panel Replacement in Instrument Panel, Gauges and Console.
  7. Install the SDM Fuse to the IP fuse block.
  8. Install the front floor kick-up panel. Refer to Kick-Up Panel Replacement - Front Floor in Interior Trim.
  9. Staying well away from both air bags, turn the ignition switch to the ON position.
    10. 9.1. The AIR BAG warning lamp will flash seven times.
    9.2. The AIR BAG warning lamp will then turn OFF.
  10. Perform the Diagnostic System Check - SIR if the AIR BAG warning lamp does not operate as described.