GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Colorado Pickup - 4WD 🢒 General Information 🢒 General Information 🢒 Clutch Pedal Replacement

Removal Procedure

    Object Number: 1302119 Size: SH
  1. Disconnect the electrical connectors (2, 4) from the following components:
    2. • The clutch pedal position switch (1)
    • The cruise control release switch (3)

    Object Number: 1302125 Size: SH

    Important: A new retainer (3) is required after removal.

  2. Complete the following in order to disengage the retainer (3) from the clutch pedal pin.
    3. 2.1. Insert a flat-bladed tool (4) between the clutch master cylinder push rod (1) and the clutch pedal (2).
    2.2. Pry the clutch master cylinder push rod (1) away from the clutch pedal assembly (2).

    Discard the retainer (3).


    Object Number: 1302122 Size: SH
  3. Remove the 4 nuts securing the clutch pedal assembly to the cowl.
  4. Remove the clutch pedal assembly from the vehicle.

Installation Procedure

    Object Number: 1302122 Size: SH
  1. Position the clutch pedal assembly over the studs.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the clutch pedal assembly nuts.

    3. Tighten
    Tighten the clutch pedal assembly nuts to 20 N·m (15 lb ft).


    Object Number: 1396381 Size: SH
  3. Insert a new retainer (3) into the clutch master cylinder push rod (1).
  4. Push the clutch master cylinder push rod (1) onto the clutch pedal pin to secure.

    5. Object Number: 1302119 Size: SH
  5. Connect the electrical connectors (2, 4) to the following components:
    6. • The clutch pedal position switch (1)
    • The cruise control release switch (3)
  6. Adjust the clutch release switch. Refer to Clutch Pedal Cruise Control Release Switch Adjustment .
  7. Adjust the clutch pedal position switch. Refer to Clutch Pedal Position Switch Replacement .
  8. Check for proper clutch pedal movement and operation.