Inflatable Restraint Seat Position Sensor Replacement Power Seat

1. Remove the seat from the vehicle. Refer to Front Seat Replacement - Bucket or Split Bench Seat Replacement.
2. Ensure that the seat is in the full rear position.



3. Locate the seat position sensor (1) under the seat on the inside of the inner seat rail.
4. Disconnect the electrical connector (3) from the seat position sensor (1).
5. Remove the 2 nuts (2) that retain the seat position sensor to the seat rail.
6. Remove the seat position sensor from the seat.

Caution: Refer to Fastener Caution in the Preface section.




1. Install the seat position sensor (1) to the seat rail with 2 nuts (2) and tighten to 9 N·m (79 lb in).
2. Connect the electrical connector (3) to the seat position sensor (1).
3. Install the seat in the vehicle. Refer to Front Seat Replacement - Bucket or Split Bench Seat Replacement.