GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Colorado Pickup - 2WD 🢒 Engine 🢒 Engine Electrical 🢒 Upper Intake Manifold Sight Shield Replacement

Removal Procedure

    Object Number: 1903860 Size: SH
  1. Remove the oil fill cap.
  2. Grasp the front of the intake manifold sight shield and lift up disengaging the grommets from the studs.
  3. Remove the intake manifold sight shield from the retainer slots.

    4. Object Number: 1696801 Size: SH
  4. Remove the intake manifold sight shield retainer bolts and retainer, if required.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1696801 Size: SH
  1. Position the intake manifold sight shield on top of the intake manifold, aligning the holes, if required.
  2. Install the intake manifold sight shield retainer bolts, if required.

    3. Tighten
    Tighten the bolts to 5 N·m (44 lb in).


    Object Number: 1903860 Size: SH
  3. Install the intake manifold sight shield tabs into the slots in the retainer.
  4. Align the intake manifold sight shield grommets with the studs.
  5. Gently push down on the intake manifold sight shield over the grommets, seating the intake manifold sight shield.
  6. Install the oil fill cap.