For 1990-2009 cars only
- Lubricate the shift lever plungers and the lever spring seat surface of the shift control housing with transmission fluid.
- Install the shift control lever assembly into the shift control housing.
- Install the shift control lever shaft boot in the retainer.
- Install a control lever housing gasket to the housing.
- Install the shift control lever retainer.
- Install the shift control lever retainer bolts.
- Install the control lever boot.
- Install the shift control lever shaft seal.
Important: Do not use a petroleum base or silicon lubricate on the shift control lever seals or boots. If a lubricant is required, use a water base liquid soap.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the retainer bolts to 20 N·m (14 lb ft).
