GM Service Manual Online
For 1990-2009 cars only

Heater Inlet Hose Replacement L61, LE5

Special Tools

J 38185 Hose Clamp Pliers

Caution: With a pressurized cooling system, the coolant temperature in the radiator can be considerably higher than the boiling point of the solution at atmospheric pressure. Removal of the surge tank cap, while the cooling system is hot and under high pressure, causes the solution to boil instantaneously with explosive force. This will cause the solution to spew out over the engine, the fenders, and the person removing the cap. Serious bodily injury may result.

Removal Procedure


    Object Number: 873722  Size: SH
  1. Remove the surge tank cap.
  2. Slide a drain pan under the front of the dash under the heater inlet hose.
  3. Remove the dash panel exterior sound barrier.

  4. Object Number: 872572  Size: SH
  5. Reposition the heater inlet hose clamp at the heater core using J 38185 .
  6. Remove the heater inlet hose from the heater core.

  7. Object Number: 872574  Size: SH
  8. Reposition the heater inlet hose clamp at the engine using J 38185 .
  9. Remove the heater inlet hose from the engine.

Installation Procedure


    Object Number: 872572  Size: SH
  1. Install the heater inlet hose to the heater core.
  2. Reposition the hose clamp to secure the hose using J 38185 .

  3. Object Number: 872574  Size: SH
  4. Install the heater inlet hose to the engine.
  5. Reposition the hose clamp to secure the hose using J 38185 .
  6. Fill the cooling system. Refer to Cooling System Draining and Filling
  7. .

  8. Remove the drain pan from under the vehicle.
  9. Install the dash panel exterior sound barrier.

Heater Inlet Hose Replacement RPO LSJ

Tools Required

J 38185 Hose Clamp Pliers

Caution: With a pressurized cooling system, the coolant temperature in the radiator can be considerably higher than the boiling point of the solution at atmospheric pressure. Removal of the surge tank cap, while the cooling system is hot and under high pressure, causes the solution to boil instantaneously with explosive force. This will cause the solution to spew out over the engine, the fenders, and the person removing the cap. Serious bodily injury may result.

Removal Procedure


    Object Number: 873722  Size: SH
  1. Remove the surge tank cap.
  2. Slide a drain pan under the front of the dashboard under the heater inlet hose.

  3. Object Number: 872572  Size: SH
  4. Reposition the heater inlet hose clamp at the heater core using J 38185 .
  5. Remove the heater inlet hose from the heater core and tilt the hose downward toward the drain pan to drain the coolant from the hose.

  6. Object Number: 1609040  Size: SH
  7. Reposition the heater inlet hose clamp at the engine using J 38185 .
  8. Remove the heater inlet hose (1) from the engine.

Installation Procedure


    Object Number: 872572  Size: SH
  1. Install the heater inlet hose to the heater core.
  2. Reposition the hose clamp to secure the hose using J 38185 .

  3. Object Number: 1609040  Size: SH
  4. Install the heater inlet hose (1) to the engine.
  5. Reposition the hose clamp to secure the hose using J 38185 .
  6. Fill the cooling system. Refer to Cooling System Draining and Filling .
  7. Remove the drain pan from under the vehicle.