Circuit Description
The body control module (BCM) stores the last 4 digits of the sensing and diagnostic module (SDM) part number, information also called restraints ID. After the BCM is reprogrammed, the restraints ID is set to zero. A restraints ID relearn needs to be performed for the BCM. For more information on this procedure, refer to Body Control Module (BCM) Programming/RPO Configuration .
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B1001 Option Configuration Error
DTC Symptom | DTC Symptom Descriptor |
|---|---|
00 | No Additional Information |
Conditions for Running the DTC
Battery voltage is between 9-16 volts and data link communications operate normally.
Conditions for Setting the DTC
The restraints ID value stored in the BCM memory is zero.
Conditions for Clearing the DTC
| • | A current DTC clears when the malfunction is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 |
Is DTC retrieved as a current DTC? | Go to Step 3 | Go to Step 4 |
3 |
Important: Perform the setup procedure for the BCM. Replace the BCM. Refer to Body Control Module Replacement . Did you complete the replacement? | Go to Step 4 | -- |
4 |
Does the DTC reset? | Go to Step 1 | System OK |
