GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

Connector End View Reference: Powertrain Control Module Connector End Views in Engine Controls - 2.0L or Engine Control Module Connector End Views in Engine Controls - 2.2L (L61)

1

Did you perform the Diagnostic System Check - Vehicle?

--

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

2

  1. Start the engine.
  2. Turn OFF all accessories.

Does the battery charge indicator remain illuminated?

--

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

3

  1. Install a scan tool.
  2. Start the engine.
  3. Turn OFF all accessories.
  4. Increase engine speed to 1,500 RPM.
  5. With a scan tool, observe the Battery Voltage parameter in the body control module (BCM) data list, engine control module (ECM)/powertrain control module (PCM) data list, and the instrument panel cluster (IPC) data list.
  6. Compare the voltages.

Are all of the voltages within the specified range?

0.9-1.1 V

Go to Step 4

Go to Step 5

4

Are the voltages displayed within the specified range?

11-16 V

Go to Step 5

Go to Charging System Test

5

Test the battery positive voltage and ground circuits of the affected module for a high resistance or open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 6

6

Inspect for poor connections at the harness connector of the affected module. Refer to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 7

7

Important: Perform the module setup procedure.

Replace the affected module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

--

Go to Step 8

--

8

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2