GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Classic 🢒 Restraints 🢒 SIR 🢒 Instrument Panel Inflatable Restraint Module Replacement

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

    Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.


    Object Number: 241293 Size: MH
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the I/P storage compartment. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gages and Console.
  3. Remove the mounting fasteners (3) from the inflatable restraint I/P module.
  4. Disconnect and remove the electrical harness (2) at the bussed electrical center passenger side.
  5. Remove the inflatable restraint I/P module (1) from the vehicle.
  6. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .

Installation Procedure

    Object Number: 241293 Size: MH
  1. Install the inflatable restraint I/P module to the cross-car beam (1).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the mounting fasteners (3) to the inflatable restraint I/P module.

    3. Tighten
    Tighten the fasteners to 10 N·m (89 lb in).

    Use hand tools only in order to achieve fastener torque. This will prevent stripping of the replacement fastener.

  3. Install and connect the electrical harness (2) at the bussed electrical center passenger side.
  4. Install the I/P storage compartment. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gages and Console.
  5. Enable the SIR system. Refer to SIR Disabling and Enabling .