GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 443800  Size: SH
  1. Remove the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.
  2. Remove the mounting bolts (3) from the radio (2).
  3. Remove the radio (2) from the I/P.
  4. Disconnect the electrical connectors (1,4) from the rear of the radio (2).
  5. Disconnect the antenna lead (5) from the rear of the radio (2).

Installation Procedure


    Object Number: 443800  Size: SH
  1. Connect the antenna lead (5) to the radio (2).
  2. Connect the electrical connectors (1,4) to the radio (2).
  3. Install the radio (2) in the I/P.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the radio mounting bolts (3) to the radio (2).
  6. Tighten
    Tighten the bolts to 2.3 N·m (20 lb in).

  7. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.
  8. Refer to Control Module References for programming and setup information.