GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Classic 🢒 Body 🢒 Interior Trim 🢒 Upper Pillar Garnish Molding Replacement

Removal Procedure

    Object Number: 282431 Size: SH
  1. Remove the I/P end cap cover from the I/P carrier.
  2. Remove the screw for the upper garnish molding in the bussed electrical center.
  3. Pull outward on the windshield side upper garnish molding  (2) to disengage the clips  (1).
  4. Remove the windshield side upper garnish molding  (2).

Installation Procedure

    Object Number: 282431 Size: SH
  1. Install the windshield side upper garnish molding  (2).
  2. Apply inward pressure to the windshield side of the upper garnish molding  (2) to engage the clips (1).

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the upper garnish molding screw.

    4. Tighten
    Tighten the screw to 2.3 N·m (20 lb in).

  4. Install the I/P end cap cover to the I/P carrier.