Schematic Reference: Audible Warnings Schematics

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Do any indicators illuminate when the chime sounds?

Go to Symptoms - Instrument Panel, Gages and Console

Go to Step 3

1. Turn OFF the ignition.
2. Remove the key from the ignition.
3. Turn the headlamp switch to OFF.
4. Open the drivers door.

Does the chime sound?

Go to Step 4

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With a scan tool, perform the Chime Tone Test in the Radio.

Does the chime stop when you select Off?

Go to Step 5

Go to Step 15

With a scan tool, observe the Park Lamp Input in the body control module (BCM) Lamp Status data list.

Does the Park Lamp Input parameter display Off?

Go to Step 7

Go to Step 6

1. Turn OFF the ignition.
2. Disconnect the BCM connector C2.
3. Connect a test lamp between the park lamp switch on input circuit and a good ground.

Does the test lamp illuminate?

Go to Step 8

Go to Step 14

1. Turn OFF the ignition.
2. Remove the key from the ignition.
3. Disconnect the BCM connector C2.
4. Connect a test lamp between the key in ignition signal circuit and battery positive voltage.

Does the test lamp illuminate?

Go to Step 9

Go to Step 14

Test the park lamp switch on input circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 10

Test the key in ignition signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 11

Inspect for poor connections at the harness connector of the headlamp switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 12

Inspect for poor connections at the harness connector of the ignition key alarm switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 13

Replace the headlamp switch. Refer to Turn Signal Multifunction Switch Replacement in Steering Wheel and Column.

Did you complete the replacement?

Go to Step 16

--

Replace the ignition switch. Refer to Ignition and Start Switch Replacement .

Did you complete the replacement?

Go to Step 16

--

Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 16

--

Replace the radio. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 16

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3