GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0621: Generator L-Terminal Circuit

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

B+

P0622

P0622

--

--

Field Duty Cycle Signal

P0622

P0622

--

--

Charge Indicator Signal

P0621

--

P0621

--

Circuit/System Description

The engine control module (ECM) uses the charge indicator signal circuit, or L-terminal circuit, to control the load of the generator on the engine. A high side driver in the ECM applies a voltage to the voltage regulator. This signals the voltage regulator to turn the field circuit ON and OFF. The ECM monitors the state of the charge indicator signal circuit.

Conditions for Running the DTC

    • The engine is running.
    • No generator, CKP sensors, CMP sensor DTCs are set.

Conditions for Setting the DTC

The charge indicator signal circuit is shorted to ground or shorted to voltage for 20 seconds.

Action Taken When the DTC Sets

    • The charge indicator turns ON.
    • The driver information center (DIC) displays the SERVICE BATTERY CHARGING SYSTEM message.

Conditions for Clearing the DTC

    • The DTC will pass when the condition for setting the DTC is no longer present for 2 seconds.
    • A history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
    • The charge indicator and DIC message will remain ON until the DTC passes or is cleared, even if the ignition is cycled.

Reference Information

Schematic Reference

Starting and Charging Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Charging System Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Testing

  1. Ignition OFF, disconnect the X1 harness connector at the generator.
  2. Ignition ON, test for less than 1 V between the signal circuit terminal 1 and ground.
  3. If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Engine running, test for greater than 3.5 V between the signal circuit terminal 1 and ground.
  5. If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  6. If all circuits test normal, test or replace the generator.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Generator Replacement
    •  Control Module References for ECM replacement, setup, and programming.