Caution: Refer to SIR Caution in the Preface section.

Preliminary Procedure

1. Remove the front seat. Refer to Front Seat Replacement - Bucket .
2. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Rezeroing .

1

Front Seat Recliner Lever (If Equipped)

Tip
Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.

2

Front Seat Adjuster Outer Finish Cover

Refer to Front Seat Cushion Outer Trim Panel Replacement .

3

Front Seat Adjuster Inner Finish Cover

Refer to Front Seat Cushion Inner Trim Panel Replacement .

4

Front Seat Cushion Cover and Pad

Tip

1. Disengage the j-channel retainers from the seat cushion frame.
2. Remove the seat cushion cover and pad from the seat cushion frame as an assembly.

5

Inflatable Restraint Front Passenger Presence Sensor Retainer (Qty: 2)

6

Inflatable Restraint Front Passenger Presence Sensor

Tip

1. Lay the seat on it's side.
2. Unhook connector from retainer on seat frame and push up through seat pan.
3. Disconnect and remove sensor.

7

Front Seat Adjuster Assembly

Refer to Front Seat Adjuster Replacement or Front Seat Adjuster Replacement .

8

Inflatable Restraint Front Passenger Presence Module Rivets (Qty: 2)

Tip
Drill out the rivets to remove and install using new rivets.

9

Inflatable Restraint Front Passenger Presence Module