GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Chevy Suburban - 4WD 🢒 HVAC 🢒 Heating, Ventilation and Air Conditioning 🢒 Sealing Washer Replacement

Removal Procedure

    Object Number: 818438 Size: SH
  1. Remove the seal washer from the A/C refrigerant component.

    2. Important: Cap or tape the open A/C refrigerant components immediately to prevent system contamination.

  2. Inspect the seal washer for signs of damage to help determine the root cause of the failure.
  3. Inspect the A/C refrigerant components for damage or burrs. Repair if necessary.

    4. Important: DO NOT reuse sealing washer.

  4. Discard the sealing washer.

Installation Procedure

    Important: Flat washer type seals do not require lubrication.

  1. Inspect the new seal washer for any signs of cracks, cuts, or damage.

    2. Do not use a damaged seal washer.

  2. Remove the cap or tape from the A/C refrigerant components.

    3. Object Number: 818438 Size: SH
  3. Using a lint-free clean, dry cloth, clean the sealing surfaces of the A/C refrigerant components.
  4. Carefully install the new seal washer onto the A/C refrigerant component.

    5. The washer must completely bottom against the surface of the fitting.

    Important: After tightening the A/C components, there should be a slight sealing washer gap of approximately 1.2 mm (3/64 in) between the A/C line and the A/C component.

  5. Assemble the remaining A/C refrigerant components. Refer to the appropriate repair procedure.