GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1996 🢒 Chevy Suburban - 4WD 🢒 Engine 🢒 Engine Controls - 6.5L 🢒 Cuts Out, Misses

Cuts Out, Misses Cuts Out and Misses

Checks

Action

Definition: A steady or jerking that follows engine speed, usually more pronounced as the engine load increases which is not normally felt above 1500 RPM or 48 km/h (30 mph).. The exhaust has a steady spitting sound at idle, low speed, or hard acceleration for the fuel starvation that can cause the engine to cut-out.

Preliminary Check

Refer to Important Preliminary Checks .

Ignition System Checks

Check for a cylinder misfire:

  1. Start the engine.
  2. Allow the engine to stabilize.
  3. Perform Injector balance test.
  4. If there is a RPM drop on all cylinders , go to Rough, Unstable, or Incorrect Idle and Stalling .
  5. If there is no RPM drop on one or more of the cylinders, or excessive variation in drop, refer to Engine Mechanical.

Engine Mechanical Checks
    • Perform a cylinder compression check. Refer to Engine Mechanical.
    • Check the engine for the following:
       - Improper valve timing
       - Bent pushrods,
       - Worn rocker arms
       - Worn camshaft lobes
       - Broken or weak valve springs Refer to Engine Mechanical.
    • Check the intake and exhaust manifold passages for casting flash. Refer to Engine Mechanical.

Fuel System Checks
    • Check the fuel system - plugged fuel filter, low fuel pressure, etc. Refer to Fuel System Diagnosis .
    • Check for water contamination in the fuel.

Additional Check

Check for Electromagnetic Interference (EMI).

The EMI on the reference circuit can cause a missing condition.

Monitoring the engine RPM with a scan tool can detect an EMI.

A sudden increase in the RPM with little change in the actual engine RPM, indicates EMI is present.

If the problem exists, check the routing of the secondary wires and the ground circuit.