GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.

Caution: DO NOT for any reason, insert a screwdriver or other small hand tools into the throttle body to hold open the throttle plate, as the wedge inside the throttle body could be damaged.


    Object Number: 1696893  Size: SH
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement.
  2. Disconnect the engine wiring harness electrical connector (3) from the electronic throttle control.

  3. Object Number: 1401966  Size: SH
  4. Remove the throttle body nuts (507) and bolts (538).
  5. Remove the throttle body (508).
  6. Remove and discard the throttle body gasket (509).

Installation Procedure


    Object Number: 1401966  Size: SH
  1. Install a NEW throttle body gasket to the intake manifold. Align the tab of the gasket with the notch in the manifold.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the throttle body (508), bolts (538), and nuts (507) and tighten to 10 N·m (89 lb in).

  4. Object Number: 1696893  Size: SH

    Note: Verify that the engine wiring harness electrical connector seal for the electronic throttle control is properly installed and not damaged.

  5. Connect the engine wiring harness electrical connector (3) to the electronic throttle control.
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement.
  7. Connect a scan tool in order to test for proper throttle-opening and throttle-closing range.
  8. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
  9. Verify that the vehicle meets the following conditions:
  10. • The vehicle is not in a reduced engine power mode.
    • The ignition is ON.
    • The engine is OFF.
  11. Perform the Throttle Learn Procedure. Refer to Throttle Learn.
  12. Inspect for coolant leaks.