Important: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Disconnect the chassis wiring harness electrical connector (1) from the EVAP canister vent solenoid.



3. Disconnect the fuel fill pipe vent pipe quick connect fitting (2) from the EVAP canister vent solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
4. Disconnect the EVAP canister vent solenoid line quick connect fitting (1) from the auxiliary EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .



5. Disengage the retainer (1) securing the EVAP canister vent solenoid to the bracket.
6. Remove the EVAP canister vent solenoid (2).

1. Install the EVAP canister vent solenoid (2).
2. Slide the EVAP canister vent solenoid onto the bracket until the retainer (1) engages the clip.



3. Connect the EVAP canister vent solenoid line quick connect fitting (1) to the auxiliary EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
4. Connect the fuel fill pipe vent pipe quick connect fitting (2) to the EVAP canister vent solenoid. Refer to Plastic Collar Quick Connect Fitting Service .



5. Connect the chassis wiring harness electrical connector (1) to the EVAP canister vent solenoid.
6. Lower the vehicle.