Special Tools

Caution: Refer to Fastener Caution in the Preface section.




1. Install the J 42386-A  (1) and bolts. Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation. Tighten the J 42386-A bolts to 50 N·m (37 lb ft).
2. Remove the camshaft position (CMP) actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement.

Warning: Refer to Camshaft Position Actuator Removal and Installation Warning in the Preface section.




3. Remove the CMP actuator solenoid valve (234).
4. Discard the solenoid valve.

1. Install a NEW CMP actuator solenoid valve (234).

With the CMP actuator properly positioned onto the camshaft, the CMP actuator solenoid valve can be threaded completely into the camshaft using light hand pressure. Tighten by hand until snug.




2. Tighten the CMP actuator solenoid valve.

2.1.	Tighten the CMP actuator solenoid valve a first pass to 65 N·m (48 lb ft).

2.2.	Tighten the CMP actuator solenoid valve a final pass an additional 90 degrees using the J 45059 .




3. Remove the J 42386-A  (1).
4. Install the CMP actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement.