For 1990-2009 cars only
- Remove the rear fascia. Refer to Rear Bumper Fascia Replacement .
- Disconnect the sensor harness.
- Remove the sensor from the sensor housing.
- Sand/grind sonic weld plastic residue from the fascia.
- Apply structural adhesive epoxy, Lord Fusor™ 127EZ or equivalent, to fascia at mating surface.
- Using the alignment tabs, install the sensor housing to the fascia.
- Allow adhesive to cure according to manufacturer's directions.
- Install the sensor to the sensor housing.
- Connect the electrical harness.
- Install the rear fascia. Refer to Rear Bumper Fascia Replacement .
The sensor housing must be painted if replaced. If reinstalled, painting will not be necessary.
Important: Do Not grind off alignment tabs.
