Circuit Description
At each power-up, the transfer case shift control module runs a self-test on the following functions:
| • | Electronically erasable programmable read only memory (EEPROM) Checksum |
| • | Read only memory (ROM) Checksum |
| • | Random access memory (RAM) Checksum |
| • | RAM Malfunction |
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC C0550 ECU Malfunction
Conditions for Running the DTC
| • | The ignition is ON. |
| • | The system voltage is 9-18 volts. |
Conditions for Setting the DTC
| • | Critical operational parameters stored in EEPROM have failed Checksum test indicating invalid data. |
| • | Masked ROM code has failed Checksum test indicating that masked ROM data is not currently valid. |
| • | ROM code has failed Checksum test indicating that ROM data is not currently valid. |
| • | One or more RAM locations have failed operational test indicating that some portions of RAM are not functional. |
Action Taken When the DTC Sets
| • | The SERVICE 4WD indicator remains illuminated for the remainder of the current ignition cycle. |
| • | The transfer case control switch does not display the current position LED while DTC C0550 is current. |
Conditions for Clearing the DTC
| • | Replace the transfer case shift control module. |
| • | Perform the Diagnostic System Check - Vehicle . |
Diagnostic Aids
Extremely low system voltage can cause this DTC to set falsely. Refer to Battery Charging .
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step has the technician attempt to reprogram the transfer case shift control module.
-
This step has the technician replace and reprogram the transfer case shift control module.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Transfer Case Control Schematics Connector End View Reference: Transfer Case Control Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
Attempt to reprogram the transfer case shift control module. Refer to Control Module References for replacement, setup, and programming. Does the DTC set after programming? | Go to Step 3 | System OK | |
Replace the transfer case shift control module. Refer to Control Module References for replacement, setup, and programming. Did you complete the repair? | System OK | -- | |
