GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Chevy Suburban - 2WD 🢒 Body and Accessories 🢒 Doors 🢒 Rear Side Door Outside Handle Replacement

Removal Procedure
  1. Remove the trim panel. Refer to Rear Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .

    3. Object Number: 277830 Size: SH
  3. Remove the outside handle mounting bolts.
  4. Remove the handle control rod from the clip retainer.
  5. Remove the outside handle from the door.

Installation Procedure
  1. Install the handle control rod to the handle clip retainer.
  2. If the lock cylinder is a replacement, apply a coating of GM P/N 12345120 or a similar lubricant to the inside of the lock case and to the cylinder keyway prior to installing the cylinder.

    3. Object Number: 277830 Size: SH
  3. Install the handle to the vehicle by completing the following steps:
    4. 3.1. Hold the handle assembly upside down.
    3.2. Insert the handle control rod into the hole in the lock.
    3.3. Turn the handle assembly right side up.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the outside handle mounting bolts.

    5. Tighten
    Tighten the bolts to 4 N·m (35 lb in).

  5. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  6. Install the trim panel. Refer to Rear Side Door Trim Panel Replacement .