Did you perform the Cruise Control System Check?

--

Go to Step 2

Go to Cruise Control System Check

1. Disconnect connector C266 at the steering column.
2. Connect a digital multimeter (DMM), set on ohms, between connector C266 pins A13 for CKT 41 (BRN) pigtail wire and A15 for the CKT 87 (GRY/BLK) pigtail wire.
3. Place the cruise control switch to the R/A position.
4. Observe the DMM.

Is there continuity?

--

Go to Step 3

Go to Step 4

1. Disconnect connector C1 at the powertrain control module (PCM).
2. Connect a DMM, set on ohms, between the PCM connector C1 pin D10 and connector C266 pin A15 for CKT 87 (GRY/BLK).

Is there continuity?

--

Go to Step 5

Go to Step 6

1. Inspect for an open in the CKT 87GRY/BLK) pigtail wire in the steering column, repair as necessary. Refer to Wiring Repairs .
2. If no opens were found, replace the cruise control switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle .

Is the repair complete?

--

Go to Cruise Control System Check

--

Replace the PCM. Refer to Powertrain Control Module Replacement/Programming in Engine Controls.

Is the repair complete?

--

Go to Cruise Control System Check

--

Repair the open in the CKT 87 (GRY/BLK) wire between the connector C266 and the PCM. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Cruise Control System Check

--