For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable.
- Remove the instrument cluster bezel.
- Remove the four screws that retain the instrument cluster.
- Remove the instrument cluster from the vehicle.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
| • | Four clips across the top edge, and four clips across the bottom edge, retain the bezel. |
| • | For vehicles equipped with tilt wheel, move the steering column to the lowest position. |
| • | For vehicles without tilt wheel, you may have to lower the column. |
| • | Disconnect the electrical connectors from the headlamp switch and the dimmer control and accessory switches. |
Keep fingers and other foreign objects away from the flexible circuit connections.
Installation Procedure
- Press the instrument cluster into the instrument panel.
- Install the instrument cluster hold-down screws.
- Connect the electrical connectors to the headlamp switch and the dimmer control and accessory switches.
- Install the instrument cluster bezel.
- Connect the negative battery cable.
