Removal Procedure
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect
the negative battery cable(s).
- Remove the lamp assembly
by completing the following steps:
| 2.1. | Push upward against the reading lamp assembly. |
| 2.2. | Turn the reading lamp assembly counterclockwise. |
| 2.3. | Lower the assembly from the console. |
- Remove the bulb and base assembly from the back of the assembly.
- Remove the bulb from the base by pulling the bulb straight out
of the base.
Installation Procedure
- Install the bulb into the base by pushing the bulb straight into
the base.
- Install the bulb and base assembly into the lens and socket assembly.
- Install the lamp assembly
into the console by pushing the lamp assembly into the console.
- Turn the lamp assembly clockwise.
- Connect the negative battery cable(s).
