Removal Procedure
- Disconnect the negative battery cable.
- Remove the instrument panel bezel. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gauges and Console.
- Remove the radio. Refer to Radio Replacement in Entertainment.
- Roll back the instrument panel. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gauges and Console.
- Remove the duct mounting screws.
- Remove the duct from the instrument panel.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the duct to the instrument panel.
- Install the duct mounting screws.
- Roll forward the instrument panel. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gauges and Console.
- Install the radio. Refer to Radio Replacement in Entertainment.
- Install the instrument panel bezel. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gauges and Console.
- Connect the negative battery cable.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 1.9 N·m (17 lb in).
