GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Chevy Suburban - 2WD 🢒 Engine 🢒 Engine Electrical 🢒 Battery Replacement

Removal Procedure

    Object Number: 84569 Size: SH
  1. Disconnect the negative battery cable from the negative battery terminal.
  2. Disconnect the positive battery cable from the positive battery terminal.
  3. Remove the battery hold-down retainer bolt (2) and retainer (3).
  4. Remove the battery (1) from the battery tray (4).
  5. Inspect the battery for:
    6. • Damage
    • Worn or corroded cables and connectors
    • Damage or foreign objects in the battery carrier
  6. If damage is noted, find and correct the cause.
  7. Clean any corrosion form the battery cables and connectors.
  8. Clean the battery tray and remove any foreign objects from it.

Installation Procedure

    Object Number: 84569 Size: SH
  1. Install the battery (1) into the battery tray (4).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Connect the hold-down retainer (3) and bolt (2).

    3. Tighten
    Tighten the hold-down retainer bolt to 15 N·m (11 lb ft).

  3. Connect the positive battery cable and the positive battery cable terminal to the battery.
  4. Connect the negative battery cable and the negative battery cable terminal to the battery.

    5. Tighten
    Tighten the battery terminals to 15 N·m (11 lb ft).