Blackout (B/O) Taillamp Replacement LSSV

1. Ensure all lamp switches are in the OFF position.
2. Remove the wiring harness strap from the marker lamp harness.
3. Disconnect the marker lamp harness connector (1) by releasing the tab.
4. Remove the nuts (2) and the ground connector (3) from the rear of the bumper.



5. Remove the marker lamp (1) from the bumper.

1. Position the marker lamp (1) onto the bumper.

Notice: Refer to Fastener Notice in the Preface section.




2. Install the nuts (2) and the ground connector (3) onto the mounting studs.

Tighten
Tighten the nuts to 2 N·m (18 lb in).

3. Connect the harness connector (1) to the marker lamp connector.
4. Install the harness into the original mounting location using the wiring harness strap.

Blackout (B/O) Taillamp Replacement Maintenance Body

1. Ensure all lamp switches are in the OFF position.
2. Remove the wiring harness strap from the marker lamp harness
3. Disconnect the marker lamp harness connector (1) by releasing the tab.
4. Remove the nuts (2) and the ground connector (3) from the rear of the bumper.



5. Remove the marker lamp (1) from the bumper.

1. Position the marker lamp (1) onto the bumper.

Notice: Refer to Fastener Notice in the Preface section.




2. Install the nuts (2) and the ground connector (3) onto the mounting studs.

Tighten
Tighten the nuts to 2 N·m (18 lb in).

3. Connect the harness connector (1) to the marker lamp connector.
4. Install the harness into the original mounting location using the wiring harness strap.