Tools Required
| • | J 44257 Wiring
Harness Connector Remover |
| • | J 44247 Internal
Wiring Harness Installer |
Removal Procedure
- Remove the oil pan and suction filter. Refer to
Oil Pan Replacement
.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect the external
wiring harness from the main transmission connector. Use J 44257
, if connector is not easily accessible.
Important: The main transmission connector is actually one end of the internal
wiring harness that protrudes through the main housing.
- Place a 30 mm or
1 3/16 inch 12-point deep socket or box-end wrench (2) over the main
transmission connector (1).
- Push inward on the socket or wrench to release the retaining "feet"
that attach the connector (1) to the main housing.
- Remove the wrench. Push inward on the electrical connector to
separate it from the main housing.
- Disconnect the internal
wiring harness connectors (1) from solenoids A through F and from the
pressure switch assembly.
Important: The solenoid retainers for E and D solenoid also retain tabs on the
wiring harness U-channel. The solenoids will remain in position even after
the solenoid retainers are removed.
- Remove the solenoid retainers (2) for solenoids E and D.
- Remove the internal wiring harness from the transmission.
Installation Procedure
- Align the tabs (8) on
the new wiring harness U-channel with the solenoid retainer slots for solenoids
E (3) and D (2) on the control valve assembly. Install the solenoid retainers
(14) for the E (3) and D (4) solenoids.
Important: The internal wiring harness connectors (7) and (9)-(13) should
be in the correct position for installation because of their pre-assembled
position in the U-channel.
- Attach the internal wiring harness connectors to solenoids A through
F and to the pressure switch assembly.
| • | Connector (13) goes to solenoid (6). |
| • | Connector (12) goes to solenoid (4). |
| • | Connector (7) goes to solenoid (5). |
| • | Connector (10) goes to solenoid (2). |
| • | Connector (11) goes to solenoid (3). |
| • | Connector (9) goes to solenoid (1). |
- Push the main transmission
connector (2) outward through hole (1) in the main housing until the retaining
"feet" on the connector are near the locked position.
- Use J 44247
to seat the retaining "feet"
on transmission connector (1).
- Install the oil pan and suction filter. Refer to
Oil Pan Replacement
.
- Connect the external wiring harness to the main transmission connector.
