- Install the glow plugs to the right cylinder bank.
- Install the glow plug harness to the right cylinder bank (1 California, 2 Federal).
- Install the glow plug power feed wire to the right cylinder bank.
- Install the glow plug harness nuts to the right cylinder bank.
- Install the glow plugs to the left cylinder bank.
- Install the glow plug harness to the left cylinder bank (1 California, 2 Federal).
- Install the glow plug controller.
- Install the glow plug controller nuts.
- Install the glow plug power feed wire to the left cylinder bank.
- Install the glow plug harness nuts to the left cylinder bank.
- Install the glow plug harness bracket bolt.
- Install the intake air heater connector.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the glow plugs to 18 N·m (13 lb ft).
Tighten
Tighten the glow plug harness nuts to 2 N·m (18 lb in).
Tighten
Tighten the glow plugs to 18 N·m (13 lb ft).
Tighten
Tighten the glow plug controller nuts to 25 N·m (18 lb ft).
Tighten
Tighten the glow plug harness nuts to 2 N·m (18 lb in).
Tighten
Tighten the glow plug harness bracket bolt to 21 N·m (15 lb ft).
