GM Service Manual Online
For 1990-2009 cars only

Circuit Description

When the engine oil level is in the normal range, the engine oil level switch is a closed switch and the engine oil level switch signal is low.

When a low engine oil level condition is present, the engine oil level switch is an open switch and the engine oil level switch signal is high. The IPC receives a class 2 message from the PCM requesting illumination of the CHECK ENG OIL LEVEL indicator.

Step

Action

Value(s)

Yes

No

Schematic Reference: Instrument Cluster Schematics

1

Did you perform the Instrument Cluster Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

2

Turn the ignition ON, with the engine OFF.

Does the CHECK ENGINE OIL LEVEL indicator display in the message center?

--

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3

  1. Install a scan tool.
  2. With the scan tool observe the Engine Oil Level Switch parameter in the PCM Engine Data 2 data list.

Does the Engine Oil Level Switch parameter display LOW?

--

Go to Step 8

Go to Step 4

4

  1. Turn the ignition OFF.
  2. Disconnect the engine oil level switch.
  3. Turn the ignition ON, with the engine OFF.

Does the Engine Oil Level Switch parameter display OK?

--

Go to Step 5

Go to Step 6

5

Test the signal circuit of the engine oil level switch for a short to ground. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 11

Go to Step 7

6

Inspect for poor connections at the harness connector of the engine oil level switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 11

Go to Step 9

7

Inspect for poor connections at the harness connector of the PCM. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 11

Go to Step 10

8

Replace the IPC. Refer to Instrument Cluster Replacement .

Did you complete the replacement?

--

Go to Step 11

--

9

Replace the engine oil level switch. Refer to the following procedures:

    •  Engine Oil Level Sensor and/or Switch Replacement in Engine Mechanical - 4.3L
    •  Engine Oil Level Sensor and/or Switch Replacement in Engine Mechanical - 4.8L, 5.3L and 6.0L
    •  Engine Oil Level Sensor and/or Switch Replacement in Engine Mechanical - 6.6L
    •  Engine Oil Level Sensor and/or Switch Replacement in Engine Mechanical - 8.1L

Did you complete the replacement?

--

Go to Step 11

--

10

Important: Program the replacement PCM.

Replace the PCM. Refer to the following procedures:

    •  Powertrain Control Module Replacement in Engine Controls - 4.3L
    •  Powertrain Control Module Replacement in Engine Controls - 4.8L, 5.3L, and 6.0L
    •  Engine Control Module Replacement in Engine Controls - 6.6L
    •  Powertrain Control Module Replacement in Engine Controls - 8.1L

Did you complete the replacement?

--

Go to Step 11

--

11

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 3