GM Service Manual Online
For 1990-2009 cars only

Diagnostic Aids

If the clutch pedal sticks or binds during clutch pedal travel, it may indicate faulty bushings or a worn or damaged release bearing.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. This step inspects the clutch system components and the operation of the clutch system.

  2. This step inspects for worn bushings.

  3. This step inspects for a faulty release bearing.

Step

Action

Yes

No

DEFINITION: The clutch pedal sticks or binds during clutch pedal travel.

1

Did you review the clutch symptom operations and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Clutch

2

Inspect the clutch pedal bushings for wear.

Are the clutch pedal bushings worn?

Go to Step 3

System OK

3

Repair the clutch pedal assembly. Refer to Clutch Pedal Replacement

Does the clutch operate properly?

System OK

Go to Step 4

4

  1. Remove the transmission. Refer to the following:
  2. •  Transmission Replacement in Manual Transmission NV - 3500
    •  Transmission Replacement in Manual Transmission NV - 4500
    •  Transmission Replacement in Manual Transmission ZF S6 - 650
  3. Inspect the clutch release bearing.

Is the release bearing faulty?

Go to Step 5

--

5

Replace the clutch release bearing. Refer to Clutch Concentric Actuator Cylinder Replacement .

Did you find and repair the condition?

Go to Step 6

Go to Diagnostic Aids

6

  1. Install the transmission. Refer to the following:
  2. •  Transmission Replacement in Manual Transmission NV - 3500
    •  Transmission Replacement in Manual Transmission NV - 4500
    •  Transmission Replacement in Manual Transmission ZF S6 - 650
  3. Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 1