GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Chevy K Silverado - 4WD 🢒 Engine 🢒 Engine Controls - 6.6L 🢒 Fuel Temperature Sensor Replacement

Removal Procedure

    Object Number: 658266 Size: SH
  1. Remove the upper intake manifold sight shield using the following procedure:
    2. 1.1. Remove the retaining bolt in the front of the shield.
    1.2. Lift up on the front of the shield.
    1.3. Lift the shield off the rear bracket.
  2. Remove the turbo outlet duct over the left valve cover.
  3. Remove the fuel temperature sensor harness connector.
  4. Remove the fuel temperature sensor from the fuel rail.

Installation Procedure

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the fuel temperature sensor.

    2. Tighten
    Tighten the fuel temperature sensor to 22 N·m (16 lb ft).

  2. Install the electrical connector to the sensor.
  3. Install the Turbo outlet duct.

    4. Tighten
    Tighten the duct clamps to 6 N·m (53 lb in).


    Object Number: 658266 Size: SH
  4. Install the upper intake manifold sight shield.

    5. Tighten
    Tighten the upper intake manifold sight shield bolt to 9 N·m (80 lb in).