GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Chevy K Silverado - 4WD 🢒 Body and Accessories 🢒 Wiring Systems 🢒 Vehicle Speed Sensor Replacement

Removal Procedure
  1. Rase the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    2. Object Number: 102535 Size: SH
  2. Disconnect the wiring harness connector.
  3. Remove the bolt securing the speed sensor to the transmission.
  4. Remove the speed sensor from the transmission.
  5. Remove the O-ring seal if not attached to the speed sensor.

Installation Procedure

    Object Number: 102535 Size: SH
  1. Install the new speed sensor and O-ring seal.
  2. Coat the seal with a thin film of transmission fluid GM P/N 12346143.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the bolt.

    4. Tighten
    Tighten the bolt to 11 N·m (97 lb in).

  4. Connect the wiring harness connector.
  5. Inspect the transmission fluid level. Refer to Fluid Capacity Specifications .