Circuit Description
The engine control module (ECM) monitors the condition of the ignition relay control circuit. If the ECM senses excessive voltage on this circuit, DTC P0612 will set.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC P0612 Fuel Injector Control Module (FICM) Relay Control Circuit
Conditions for Running the DTC
The ignition is ON.
DTC P0612 runs continuously once the above condition is met.
Conditions for Setting the DTC
The feedback voltage does not match the output state for more than 1 second.
Action Taken When the DTC Sets
| • | The control module illuminates the malfunction indicator lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails. |
| • | The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records. |
Conditions for Clearing the MIL/DTC
| • | The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail. |
| • | A current DTC, Last Test Failed, clears when the diagnostic runs and passes. |
| • | A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic. |
| • | Clear the MIL and the DTC with a scan tool. |
Diagnostic Aids
If the engine starts, the ignition relay control circuit is shorted to power intermittently.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Control Module Connector End Views or Engine Controls Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Attempt to start the engine. Does the engine start? | -- | Go to Diagnostic Aids | Go to Step 3 |
3 |
Does the test lamp illuminate? | -- | Go to Step 5 | Go to Step 4 |
4 | Measure the resistance of the coil circuit of the relay with a DMM. Does the resistance measure within the specified range? | 60-80 ohms | Go to Step 7 | Go to Step 6 |
5 | Repair the short to battery or ignition voltage on the relay control circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 8 | -- |
6 | Replace the relay. Did you complete the replacement? | -- | Go to Step 8 | -- |
7 | Replace the ECM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 8 | -- |
8 |
Did the DTC fail this ignition? | -- | Go to Step 2 | Go to Step 9 |
9 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? | -- | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | System OK |
