Removal Procedure
Important:
• Ensure that the control lever is positioned into the mechanical third or fourth gear prior to removal of the shift lever from the transmission. The transmission must remain in this state when the shift lever is removed. • Do not disassemble the transmission shift lever. Internal parts for this shift lever are not available. Opening the shift housing lever voids the warranty. • When removing the shift lever from the transmission, use the exposed bolts on the base of the lever.
- Remove the control lever and boot. Refer to Control Lever and/or Boot Replacement .
- Remove the transmission support. Refer to Transmission Support Replacement .
- Lower the transmission slightly to access to insulator.
- Cut one side of the insulator in order to remove it. Remove the insulator.
- Remove the shift lever and seal.
Installation Procedure
- Install the shift lever seal and lever.
- Install the shift lever bolts.
- Install the insulator.
- Raise the transmission.
- Install the transmission support. Refer to Transmission Support Replacement .
- Install the control lever and boot. Refer to Control Lever and/or Boot Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 20 N·m (15 lb ft).
