Instrument Panel Trim Pad Replacement Chevrolet

1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
2. Remove the defroster grille. Refer to Defroster Grille Replacement .
3. Remove the end caps. Refer to Instrument Panel Outer Trim Cover Replacement .
4. Open the instrument panel compartment.
5. Remove the screws at the top of the instrument panel compartment.
6. Remove the trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .



7. Remove all of the hex head screws (1) attaching the instrument panel trim pad (2).
8. Remove the instrument panel trim pad (2) from the instrument panel.

1. Install the pad (2) to the instrument panel.
2. Install the hex head screws (1) attaching the trim pad (2) to the instrument panel.
3. Install the trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
4. Install the screws for the instrument panel compartment.
5. Install the end caps. Refer to Instrument Panel Outer Trim Cover Replacement .
6. Install the defroster grille. Refer to Defroster Grille Replacement .
7. Enable the SIR system. Refer to Enabling the SIR System in SIR.

Instrument Panel Trim Pad Replacement Pontiac

Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

•	Air bag deployment

•	Personal injury

•	Unnecessary SIR system repairs

In order to avoid the above conditions, observe the following guidelines:

•	Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.

•	If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
2. Remove the defroster grille. Refer to Defroster Grille Replacement .
3. Remove the instrument panel valance (4) by lifting upward to release the retainers.
4. Remove the end caps. Refer to Instrument Panel Outer Trim Cover Replacement .
5. Open the instrument panel compartment.
6. Remove the retaining screws for the glove box trim plate and the accessory trim plate.
7. Remove the accessory trim plate.



8. Remove all of the screws (1) attaching the instrument panel trim pad (2).
9. Remove the instrument panel trim pad (2) from the instrument panel.

1. Install the pad (2) to the instrument panel.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the screws (1) attaching the trim pad (2) to the instrument panel.

Tighten
Tighten the screws to 2 N·m (18 lb in).

3. Install the accessory trim plate.
4. Install the screws to the accessory trim plate and the glove box trim plate.
5. Install the end caps. Refer to Instrument Panel Outer Trim Cover Replacement .
6. Install the instrument panel valance (4) by pushing downward .
7. Install the defroster grille. Refer to Defroster Grille Replacement .
8. Enable the SIR system. Refer to Enabling the SIR System in SIR.