Notice: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
2. Disconnect the engine wiring harness electrical connector (3) from the electronic throttle control (ETC) (2).



3. Remove the throttle body bolts (9) and nuts (10).
4. Remove the throttle body (8).
5. Remove and discard the throttle body gasket (7).

1. Install a NEW throttle body gasket (7).
2. Install the throttle body (8).

Notice: Refer to Fastener Notice in the Preface section.

3. Install the throttle body bolts (9) and nuts (10).

Tighten
Tighten the bolts/nuts to 10 N·m (89 lb in).




4. Connect the engine wiring harness electrical connector (3) to the ETC (2).
5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
6. Perform the throttle learn procedure. Refer to Throttle Learn .