Notice: Refer to General Repair Instructions in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the transmission oil pan. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .
3. Disconnect the vehicle wire harness electrical connector from the transmission electrical connector passage sleeve. Refer to Automatic Transmission Inline 16-Way Connector Description .

1

Electrical Connector Slide Lock

Tip
Pull down on the slide lock to remove the sleeve. Push up on the slide lock after sleeve installation.

2

Electrical Connector Passage Sleeve

Tip
Use the DT 47715 DT 47715 and J 42183 J 42183 to remove and install the electrical connector passage sleeve.

3

NEW O-Ring Seals (Qty: 2)

4

NEW Lip Seal