Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category |
DTC Descriptor
DTC C0569 00: System Configuration WrongDiagnostic Fault Information
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
System Disabled Information Stored Invalid Serial Data Received | -- | -- | -- | C0569 00 |
Circuit/System Description
The electronic brake module (EBCM) receives a GMLAN message from the instrument panel cluster (IPC) indicating the the level of vehicle that the EBCM is installed to. This DTC will set if there is a mismatch between the information originally programmed to the EBCM (at the time of original installation) and the RPO data supplied by the IPC.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The EBCM has not undergone the programming procedure.
Action Taken When the DTC Sets
One or more of the following actions may occur:
| • | The EBCM disables the Antilock Brake System (ABS)/Traction Control System (TCS)/Electronic Stability Control (ESP)/Electronic Brake Distribution (EBD) for the duration of the ignition cycle. |
| • | The multi function display (MFD) displays the ABS Fault message. |
| • | The multi function display (MFD) displays the Traction Ctrl Off message. |
| • | The multi function display (MFD) displays the Stability Ctrl Off message. |
Conditions for Clearing the DTC
A current DTC will clear when the EBCM has undergone the setup procedure.
Diagnostic Aids
A newly replaced EBCM will set DTC C0569 on its initial ignition ON cycle.
Reference Information
Schematic Reference
Antilock Brake System Schematics .
Connector End View Reference
Component Connector End Views .
Electrical Information Reference
| • | Circuit Testing . |
| • | Wiring Repairs . |
Scan Tool Reference
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
