GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category

DTC Descriptor

DTC B3873 00: Front Washer Relay Circuit

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Windshield Washer Switch Signal

2

1

3

--

Windshield Washer Pump Control

1

1

2

--

Windshield Washer relay Control

2

1

B3873

--

Windshield Washer Pump Ground

--

1

--

--

Windshield Wiper Switch Ground

--

3

--

--

1. Washer Inoperative

2. Washers Always ON

3. Windshield Wiper System Malfunction

Circuit/System Description

The windshield washer function is controlled by the body control module (BCM). When the washer switch is pressed, ground is applied through the switch contacts and the signal circuit to the BCM indicating the wash request. The BCM then applies ground through the control circuit to the coil side of the WSH Relay energising the relay. With the relay energised, battery voltage from the WPR fuse is applied through the switch contacts of the relay, the WSW/PUMP Fuse, and the control circuit to the windshield washer fluid pump.

Conditions for Running the DTC

This DTC can set only when the output is actively being requested by the BCM.

Conditions for Setting the DTC

This DTC sets if the BCM detects a short to battery voltage in the windshield washer pump relay control circuit.

Action Taken When the DTC Sets

The BCM will not activate the output.

Conditions for Clearing the DTC

    • The condition for setting the DTC is no longer present.
    • The current DTC will become history when the request for the output is removed.
    • The history DTC will clear after 50 fault-free ignition cycles.

Reference Information

Schematic Reference

Wiper/Washer Schematics .

Connector End View Reference

Component Connector End Views .

Electrical Information Reference

    •  Circuit Testing .
    •  Connector Repairs .
    •  Testing for Intermittent Conditions and Poor Connections .
    •  Wiring Repairs .

Scan Tool Reference

Control Module References

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the underhood fuse block.
  2. Connect a test lamp between the control circuit and battery voltage.
  3. Command the Wiper Washer Motor ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
  4. If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, test or replace the body control module.
    If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or replace the body control module.
  5. If all circuits test normal, test or replace the underhood fuse block.

Repair Instructions

Important: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Underhood Electrical Center or Junction Block Replacement .
    •  Control Module References for BCM replacement, programming, and setup