GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to Safety Glasses Caution in the Preface section.

    Caution: Refer to Vehicle Lifting Caution in the Preface section.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the engine splash shield. Refer to Engine Splash Shield Replacement.

  3. Object Number: 1957935  Size: SH
  4. Remove the lower engine mount retaining nuts (1).
  5. Lower the vehicle.

  6. Object Number: 1957936  Size: SH
  7. Position the EN 46114  (2) on the engine (1).
  8. Notice: Refer to Fastener Notice in the Preface section.

  9. Install the EN 46114 to cylinder head retaining bolts (3).
  10. Tighten
    Tighten the bolts to 50 N·m (36 lb ft).

    Important: Use a suitable tool to raise the engine.

    Important: When lifting the engine assembly, observe the clearance between the rear of the engine assembly and the dash panel.

  11. Raise the engine until the weight of the engine is removed from the left hand engine mount.

  12. Object Number: 1957938  Size: SH
  13. Remove the left hand engine mount to engine mount bracket retaining nut (3).
  14. Important: If required raise the engine further to provide adequate space.

    Important: When lifting the engine assembly, observe the clearance between the rear of the engine assembly and the dash panel.

  15. Remove the left hand engine mount (5) from the left hand engine mount bracket (1).
  16. Important: DO NOT distort or bend the left hand engine mount heat shield (4).

  17. Remove the left hand engine mount bracket to cylinder block retaining bolts (2).
  18. Remove the left hand engine mount bracket (1).

Installation Procedure


    Object Number: 1957938  Size: SH

    Important: DO NOT distort or bend the left hand engine mount heat shield (4).

  1. Install the left hand engine mount bracket (1).
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the left hand engine mount bracket to cylinder block retaining bolts (2).
  4. Tighten
    Tighten the bolts to 60 N·m (44 lb ft).

  5. Position the left hand engine mount (5) on the left hand engine mount bracket (1).
  6. Install the left hand engine mount to engine mount bracket retaining nut (3).
  7. Tighten
    Tighten the nut to 80 N·m (59 lb ft).

  8. Lower the engine until the weight is resting on the left hand engine mount.
  9. Caution: Refer to Safety Glasses Caution in the Preface section.

    Caution: Refer to Vehicle Lifting Caution in the Preface section.

  10. Raise the vehicle.

  11. Object Number: 1957935  Size: SH
  12. Install the engine mount to front subframe retaining nut (1).
  13. Tighten
    Tighten the nuts to 80 N·m (59 lb ft).

  14. Install the engine splash shield. Refer to Engine Splash Shield Replacement.
  15. Lower the vehicle to the ground.

  16. Object Number: 1957936  Size: SH
  17. Remove the EN 46114 to cylinder head retaining bolts (3).
  18. Remove the EN 46114  (2) from the engine (1).