GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Camaro 🢒 Engine 🢒 Engine Mechanical - 3.8L 🢒 Engine Oil and Oil Filter Replacement

Removal Procedure
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Position the oil drain pan under the engine oil drain plug.

    3. Object Number: 190564 Size: SH
  3. Remove the engine oil drain plug.
  4. Clean and inspect the engine oil drain plug, replace if necessary.
  5. Clean and inspect the engine oil drain plug sealing surface on the oil pan, replace the oil pan if necessary.

    6. Object Number: 440847 Size: SH
  6. Remove the oil filter.
  7. Clean and inspect the oil filter sealing area on the oil filter adapter, replace if necessary. Refer to Oil Filter Adapter and Bypass Valve Assembly Replacement .

Installation Procedure

    Object Number: 440847 Size: SH
  1. Lightly oil the replacement oil filter gasket with clean engine oil.
  2. Install a new engine oil filter. Tighten the new oil filter to ¾ to 1 full turn, after the filter gasket contacts the oil filter mounting surface.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 190564 Size: SH
  3. Install the engine oil drain plug.

    4. Tighten
    Tighten the engine oil drain plug to 30 N·m (22 lb ft).

  4. Remove the oil drain pan.
  5. Lower the vehicle.
  6. Fill the engine with new engine oil.
  7. Start the engine.
  8. Inspect for oil leaks after engine start up.
  9. Turn off the engine and allow the oil a few minutes to drain back into the oil pan.
  10. Remove the oil level indicator from the oil indicator tube.
  11. Clean off the indicator end of the oil level indicator with a clean paper towel or cloth.
  12. Install the oil level indicator into the oil level indicator tube until the oil level indicator handle contacts the top of the oil level indicator tube.
  13. Again, remove the oil level indicator from the oil level indicator tube keeping the tip of the oil level indicator down.
  14. Check the level of the engine oil on the oil level indicator.
  15. If needed add or drain the engine oil to the correct level.