Removal Procedure
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect
the negative battery cable.
- Relieve the fuel system pressure. Refer to the
Fuel Pressure Relief
.
- Drain the fuel tank. Refer to
Fuel Tank Draining
.
- Remove the fuel tank. Refer to
Fuel Tank Replacement
.
- Remove the fuel sender assembly. Refer to
Fuel Sender Assembly Replacement
.
- Remove the fuel pressure regulator retaining clip (2).
- Remove the fuel pressure regulator (3) from the housing on the
fuel return pipe.
Installation Procedure
- Lubricate the new fuel
pressure regulator large and small O-rings with clean engine oil.
- Install the new fuel pressure regulator large and small O-rings
on the fuel pressure regulator.
- Install the new fuel pressure regulator filter screen.
- Install the fuel pressure regulator (3) into the housing on the
fuel return pipe.
- Install the new fuel pressure regulator retaining clip (2).
- Install the fuel sender assembly. Refer to
Fuel Sender Assembly Replacement
.
- Perform the fuel tank leak check. Refer to
Fuel Tank Leak Test
- Install the fuel tank. Refer to
Fuel Tank Replacement
.
- Refill the fuel tank.
- Install the fuel filler cap.
- Connect the negative battery cable.
- Inspect for leaks.
| 12.1. | Turn ON the ignition for 2 seconds. |
| 12.2. | Turn OFF the ignition for 10 seconds. |
| 12.3. | Turn ON the ignition. |
| 12.4. | Check for fuel leaks. |
- Perform the idle learn procedure. Refer to
Idle Learn
.
