Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the entire Power Folding Top System Check performed?
| --
|
Go to Step 2
| Go to
Power Folding Top System Check
|
2
|
- Turn the ignition switch to the RUN position.
- Use a test light in order to backprobe between folding top switch
connector terminal F and ground.
Does the test light illuminate?
| --
|
Go to Step
3
|
Go to Step
4
|
3
|
- Use a test light in order to backprobe between folding top switch
connector terminal A and ground.
- While observing the test light, press the folding top switch to
the DOWN position.
Does the test light illuminate?
| --
|
Go to Step
5
|
Go to Step
6
|
4
| Repair the open in circuit 341,
between the folding top switch terminal F and the IP fuse block.
Is the repair complete?
| --
|
Go to Step
13
| --
|
5
| Use a test light in order to backprobe between folding
top switch connector terminal E and B+.
Does the test light illuminate?
| --
|
Go to Step
8
|
Go to Step
7
|
6
|
- Test for a poor connection at the folding top switch connector
terminal A and terminal F.
- If the connection is OK, replace the folding top switch.
Is the repair complete?
| --
|
Go to Step
13
| --
|
7
| Use a test light in order to backprobe between folding
top switch connector terminal H and B+.
Does the test light illuminate?
| --
|
Go to Step
14
|
Go to Step
15
|
8
|
- Disconnect the folding top pump assembly connector.
- Connect a test light between folding top pump assembly connector
terminal B (the instrument panel harness side) and ground.
- While observing the test light, press the folding top switch to
the DOWN position.
Does the test light illuminate?
| --
|
Go to Step
10
|
Go to Step
9
|
9
| Repair an open or a short to ground
in circuit 163, between the folding top switch and the convertible
folding top pump assembly.
Is the repair complete?
| --
|
Go to Step
13
| --
|
10
|
- Connect a test lamp between top pump assembly connector terminal A
(on the instrument panel harness side) and ground.
- While observing the test light, press the folding top switch to
the UP position.
Does the test light illuminate?
| --
|
Go to Step
12
|
Go to Step
11
|
11
| Repair an open or a short to the
ground in circuit 162, between the folding top switch and the folding
top pump assembly.
Is the repair complete?
| --
|
Go to Step
13
| --
|
12
|
- Test for a poor connection at the folding top pump assembly.
- If the connection is OK, replace the folding top pump assembly.
Refer to
Power Folding Top Pump with Motor Replacement
.
Is the repair complete?
| --
|
Go to Step
13
| --
|
13
|
- Turn the ignition switch to the OFF position.
- Reconnect all connectors/components removed.
Have all the repairs been made?
| --
| Go to
Power Folding Top System Check
| --
|
14
|
- Test for a poor connection at folding top switch connector terminal E.
- If the connection is OK, replace the folding top switch.
Is the repair complete?
| --
|
Go to Step
13
| --
|
15
| Repair the poor connection or open in circuit 1350.
Is the repair complete?
| --
|
Go to Step
13
| --
|
