Sunroof Panel/Window Garnish Molding Replacement ZRX/Xtreme w/ CF5

1. With a medium flat-bladed tool, remove the service cover.



2. Remove the motor/actuator trim cover screw (2).



3. Lower the motor/actuator trim cover and remove the sunroof switch (4) from the cover (5).



4. Remove the 2 short screws (1, 2) from the sunroof panel window garnish molding.
5. Remove the 8 screw covers (3) from the lower sunroof panel window garnish molding.



6. Remove the 8 garnish molding screws.
7. Remove the sunroof panel window garnish molding from the vehicle.

1. Position the garnish molding to the headliner.
2. Ensure the sunroof switch wiring is positioned properly through the garnish molding.



3. Install one short front screw (1) and install one long rear screw in order to hold the garnish molding (3) in position.

Notice: Refer to Fastener Notice in the Preface section.




4. Install the remaining screws including the one other short screw next to the motor/actuator.

Tighten
Tighten the screws to 1.5 N·m (13 lb in).

5. Install the 8 sunroof panel window garnish molding screw covers.



6. Position the sunroof switch (4) to the motor/actuator trim cover (5).
7. Locate switch to cover in order to secure.
8. Position motor/actuator trim cover to the sunroof panel window garnish molding.



9. Install the motor/actuator trim cover screw (2).

Tighten
Tighten the screw to 1.5 N·m (13 lb in).

10. Install the motor/actuator service cover.