For 1990-2009 cars only
Removal Procedure
- Remove the instrument panel. Refer to Instrument Panel Carrier Replacement .
- Remove the brake switch. Refer to Stop Lamp Switch Replacement in Hydraulic Brakes.
- Remove the brake booster pushrod from the brake pedal. Refer to Power Vacuum Brake Booster Replacement in Hydraulic Brakes.
- Remove the following upper steering column support bracket fasteners:
- Remove the brake pedal from the upper steering column support bracket. Refer to Brake Pedal Replacement in Hydraulic Brakes.
Important: The upper steering column support bracket is not serviceable.
| • | The 4 flange nuts |
| • | The 2 bolts |
Installation Procedure
- Install the brake pedal to the upper steering column support bracket. Refer to Brake Pedal Replacement in Hydraulic Brakes.
- Install the upper steering column support bracket fasteners.
- Install the brake switch. Refer to Stop Lamp Switch Replacement in Hydraulic Brakes.
- Install the brake booster pushrod to the brake pedal. Refer to Power Vacuum Brake Booster Replacement in Hydraulic Brakes.
- Install the instrument panel. Refer to Instrument Panel Carrier Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
| • | Tighten the nuts to 25 N·m (18 lb ft). |
| • | Tighten the bolts to 25 N·m (18 lb ft). |
